How To Remove Honeywell Thermostat Cover

Honeywell thermostat covers are usually easy to remove, you need to make sure that you do it correctly to protect the unit.

If you pull it off incorrectly, you could crack the cover or break the clips that hold it in place, which might force you to replace the thermostat. In this post, I am going to share with you how to remove Honeywell thermostat cover without cracking it.

Most Honeywell thermostat covers come off the same way, but it’s always good to check the manual and proceed slowly to prevent any damage.

When to remove Honeywell thermostat cover?

My recommendation is that if your thermostat is working without any issue, do not try to fix it or remove the cover. 

If you have a battery-powered thermostat, you might need to remove the cover when you have to change the batteries, you do this when you see the ‘ low battery ‘ message.

Another time you will need to remove the thermostat cover is when the thermostat is not working properly and need to perform troubleshooting on it. For example, you might need to check the wiring to ensure everything is connected properly.

Preparing to remove the cover

If you have a battery-powered thermostat you can skip this step, but if your thermostat is connected to the power, it is always best to shut off the power to the thermostat before you do any type of work on it.

How To Remove Honeywell Thermostat Cover?

On most Honeywell thermostat models, all you have to do to remove the cover is to pull it off, but some could have tabs or clips that you need to push to release it.

Before pulling on the cover, do a quick inspection to look for tabs, clips, or finger holds that indicate how to remove the cover. If you pull first without looking, you could break the cover.

How Do I Take the Cover Off a Honeywell T6 Thermostat?

You can take the cover off a Honeywell T6 Thermostat by pushing up on the device and pulling it off its UWP mounting system.

This will let you access the batteries and any wiring for the device. You can then snap the T6 Thermostat back onto the mounting system so that it resumes operation.

How to take the cover off Honeywell thermostats 3000 series?

Honeywell thermostats from the 3000 series require you to pull at the bottom of the thermostat to separate it from the wall plate.

Pull firmly along the bottom without pulling so hard that you break it. This should release the thermostat from the wall plate.

How to remove the cover off Honeywell T4 Pro thermostats?

Removing the Honeywell T4 Pro thermostat is simple: just pull it from the wall. Pull gently, and wiggle it a bit if necessary. It should pop off easily.

Important Points to Remember

  • Always have the power off before starting anything. That will protect you from any electrical shocks when removing the cover from Honeywell thermostats.
  • If you feel you can’t, do it, then call in a specialist to help you. Most times, there is a helping number on the thermostat.

How to put the Cover Back On

After finishing working on your thermostat, now it is time to put it back as it was before, all you need to do is to push the cover back in the place opposite of how you removed it.

For most Honeywell thermostats models, you will need to push the cover into the wall plate, if you have a wired thermostat, just turn the power back on and the thermostat should be on, if not double-check the connection or call the electrician.

Recommended thermostat replacement

If your thermostat is not working at all and you could not fix it, We will recommend you to check out one of the best thermostats available today.

nest learning thermostat

Conclusion

That is it, that is how to remove Honeywell thermostat cover, if do you want a detailed process for a specific Honeywell thermostat model please leave it in the comment section below or contact us and we will send you the step by step process free of charge.

 

 

 

 

 

Leave a Comment